Chili Pepper Doodads - Directions

Think Safety:

Be proactive about safety. Take classes, do research, and talk with experts. Actively work to identify, and then reduce or eliminate hazards. You are responsible for your own safety and long term health.
Always use the correct filtered glasses to protect your eyes.
Wear appropriate clothing and footwear.
Always work with proper ventilation. Talk with an expert about your situation.
Set up and operate your torch system safely. Take a class or get an expert to show you.
Keep your workspace clean and organized. Set up your tools and glass so you don't need to reach over or around the torch.
Be careful with water. Putting hot tools or glass in water can generate steam. Long tubes can create jets of steam.
Watch out for repetitive strain injury (RSI). Take breaks, watch your posture, and cushion your elbow rests.
Always remove and clean your beads while wet to minimize bead release dust in the air.

Chili Pepper Garage Door Holder

Holding the tool paralel to the Chili Pepper, insert the right angle end into the gap at the top of either side latch.
Twist the tool over the top of the Chili Pepper.
When you lift the door, just hook the door handle into the end hook of the tool.

Chili Pepper Kiln Rack

Remove any labels or packaging.
Insert the rack into your kiln with the long bar towards the back.
You can use the rack with the teeth up or down. The small teeth allow you to space the beads more easily.
Place it with the bar about 1" from the back wall.
As you finish beads, place them with the end of the rod resting on the rack.
After they have soaked for a while, if you need more space, you can pull beads off the rack gently with the door closed.